• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Fiat 500 Replacement Key Fob

It could be time to change the battery if the 500 remote key fob is not working. If you replace the battery but it isn't working it could be the issue somewhere else.

At United Locksmith, we specialize in making new keys for old automobiles. We have all of the necessary tools and parts for this service.

Dead Coin Battery

A dead battery is the main reason for your Fiat 500 keyfob not locking or unlocking the doors. The battery inside the key fob will deplete quickly when you don't utilize it often enough. If your remote started to show signs of weakening like a loss of range and then completely stopped working, the battery is probably dead.

The battery in the key fob is secured by metal clips that hold it in place. If the clips are not tight, they can cause problems with contact that can prevent your remote from receiving power. With a small flathead screwdriver, pry the retaining clip to remove the current battery and then insert a fresh one. Choose a battery that is the same voltage, size, and specifications as the original.

The key fob might also be damaged or corroded by water exposure. Even a brief bath in warm, soapy water could damage the chip. It is recommended to keep your key fob in a dry location.

Water Damage

Water damage could be the reason for your key fob's not functioning properly. Key fobs are fitted with rubber seals that prevent them from being damaged by rain or splashes of water, however it is vital to keep your car keys away from the pool, ocean and the washing machine!

The key fob contains an electronic chip that transmits a signal to your car's immobilizer system. The chip is what allows the 500 to start and lock. If it gets wet, however it won't work.

Try cleaning the inside electronics of your keyfob using isopropyl alcohol, or an electronic cleaner to determine whether they're still functioning. It is recommended to replace a key fob if it is submerged in salt water instead of trying to repair it yourself.

While a replacement key for fiat 500 fob can cost a little money, it is a lot cheaper than having to pay for your Fiat 500 to be towed to a dealership and fixed! You can also make it yourself with only a few steps. Make sure you have the right battery type before you attempt to open your key fob. This task is much easier than it looks, and there are step-by-step instructions online for virtually any key fob for your car.

Faulty Chip

The chip located within the key fob communicates with the car's immobiliser system to ensure the car is capable of starting when the correct key is used. If the chip is damaged or damaged in any way your car will not start.

Damage to the water or a dead cell battery are the two most frequent causes of a faulty chip. It is recommended to leave the task to a professional locksmith, fiat key programmer who will be able to replace the chip in a short time and at a a reasonable price.

If your key fob stops functioning after exposure to clean water from the tap or rain, take out the battery and clean the electronic component with a towel to ensure it's completely dry before putting it back into. If the key fob fails to work it's most likely a fried chip and Programmers is required to be replaced.

A few people will visit their dealer if they require an entirely new Fiat fob. However, this can be costly. If you are looking for a low-cost solution to have your fiat 500 Key Fob not Working key fob fixed, look no further than United Locksmith. We have the equipment and know-how needed to repair your Fiat key fob in a quick and professional manner.

Faulty Receiver Module

Fiat key fobs transmit signals up 50 feet away to the vehicle, which allows it to unlock and lock the doors (and start the vehicle if it has automatic transmissions). However there are a few factors that could cause the fob to stop functioning. This can be caused by a dead coin-battery water damage, worn out buttons an issue with the receiver, signal interference, or malfunctioning chips.

If the fob was in a pocket which has been subject to extreme trauma, such as being dropped on hard floor or getting washed in a washer and it isn't capable of communicating with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept a signal from a genuine original key, and not from any other.

You'll have to replace the fob if this happens. A professional locksmith will take care of the entire process of replacing keys including programming a new key to your 500. In fact, they can provide you with a replica key that functions exactly the same as the original fob (and costs a fraction of the cost).