• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai's greater dimensions give it an SUV-like feel. Its 19-inch alloy wheels in Ti and STL models may also be firm. The front tyres may lose grip on rough surfaces and its CVT could occasionally exhibit wrist-flexing torque steer.

This is generally caused by the battery of a coin that is dead. It can be easily replaced in minutes. Make sure the replacement battery is of the same size, voltage and specification.

Water Damage

One of the most frequent reasons a Nissan key fob might display the "key ID is incorrect" message is due to water damage. The rubber seals on the key fob are designed to protect the chip's electronic components, however prolonged exposure to moisture could cause it to malfunction effectively. It's normal to see this if your keyfob has been dropped into the ocean or in a pool. But it can also occur when it becomes wet from rain or soapy hands.

If your key fob is exposed to water for a prolonged period of time, it might need to be cleaned using isopropyl alcohol, or electronic cleaner. In addition, it may require the attention of an expert for repair or replacement.

If your key fob does require replacement the process is easy. Make sure you have the proper multipack (CR2032 3V). Open the back and front cases using a small flathead screwdriver. It is necessary to remove the metal retaining clips and remove the battery that was in place, and then put in the new one. After reassembling your fob, put the mechanical key back in its place and make sure it functions as intended. If it does not, you'll need to take it to an Nissan dealer or a professional auto locksmith for replacement of the key chip. Fortunately the chip isn't usually damaged by water exposure which means that this shouldn't be too expensive.

Dead Coin Battery

Another common reason the reason your Nissan Qashqai key fob may not function is that the battery for the coin is dead. The batteries typically last for 3-5 years, but they are susceptible to becoming depleted over time, especially when the fob is dropped frequently. You can replace the battery, but make sure it is the same voltage and same size as the first. If you replace the battery, it could cause the key to be assigned an incorrect key ID. This could prevent it from being paired with your vehicle.

The best way to change the battery on the Nissan Qashqai Key Fob is to open it with a small flat-head screwdriver. Push in the screwdriver in an angled notch on the bottom of the fob, and twist gently to separate the two parts of the key fob. Remove the old CR2025 battery and replace it with a brand new one, taking note of the location of the previous one inside the fob.

Check the terminals for any dirt or water damage prior to installing the new battery. If there is clean the terminals using small amounts of isopropyl alcohol. Make sure that the pole cables are properly connected. They must be connected to the positive and negative poles of your battery.

Fault Diagnosis

If your Nissan Qashqai key fob stops working after exposure to pure tap water or rain it could be an indication of an internal chip problem. The battery replacement won't fix this issue, and you'll have to purchase a new key fob. If you dropped the key fob on the ground and it stopped working immediately it's most likely due to damage to the internal chip. If you clean the chip using isopropyl ethanol and a paper towel and then insert it into the key fob, you will usually get it working again.

One common error you will see on your car's dashboard is "Key ID Not Correct." This means that the vehicle cannot recognize the key fob, and will not allow it to start the engine. This issue can be caused by various ways, including water damage, problems that are undetectable in the key fob's circuitry or RFID interference.

If the 12 volt battery inside your key fob is empty or Jejucordelia.com/eng/bbs/board.php?bo_table=review_e&wr_id=288756 isn't supplying sufficient electric current it will cease to function. This can affect the remote keyless system as well as central locking on your nissan juke spare key Qashqai, as well as stopping you from starting your engine with the key fob (if equipped with Intelligent Key). Check the battery in the key fob if you're not able to lock or unlock your door by hand. You could also try re-inserting the battery to reset the transmitter.

Reprogramming

Unless the key fob has been submerged in salt water the key fob should be able to be revived after a simple wash with clean water. You can also clean the electronic chip with isopropyl or electronic cleaner. If none of these works it is possible to replace the key fob.

If your Nissan Intelligent Key is still not working, it could be an issue with the connection between it and your car. To reconnect it, begin by turning the key in the ignition without starting the car. Continue doing this until the hazard light blinks twice. Turn the vehicle off and take away the keys.

Open the fob compartment in your vehicle. It is typically located in a door jamb on the driver's side door handle, or under an armrest. Find the small "program" button and press it. When the process is complete, you should hear the sound of a chime.

Now that your Intelligent Key is relinked to the car is the time to test it out. Use all the buttons on the key while at a distance from the vehicle. If the lights flash or the horn sounds, then the key is successfully connected to the Nissan. You can also test it close to the Nissan.